how to level above ground pool already up

I read reviews that some people say you must dig up where the pool lays and level it out. As stated in the manufacturer’s instructions, the ground on which the pool sits must be level.Did you notice that the sagging is coming from the level of the feet? One is to to get the pool setup level on the first try. Once empty, disassemble the pool and resume the landscaping from the beginning.Are you sure that the ground was level before installing your pool, but it is still sagging or tilting? But in all cases, it will be best to rethink its location. Jun 20, 2010, 08:09 PM That may be because of problems with the initial setup or because legs settled into the ground sometime after. When you go to check on the progress of things, you notice that your brand new pool is tilting sideways. Sorry but you have to start over and now you the have the correct instructions to follow. Then you have waited long hours for it to be filled. So, the flooding of your neighbor’s residence may not be taken casually. What is the easiest way to level the ground in preparation for putting up a rectangular pool? You can level the ground, for example, by installing a concrete slab, or you can also earth the ground.Is it that the nature of the terrain is the problem (sandy or easily waterlogged)? Then several tons of water will flow into your garden. Bought my home with the pool already in place. According to leveller it is approx 2 inches short. Installed on a sandy, wet ground, above a water table, the above-ground swimming pool can move, sag, or tilt. You would need to level the uneven surface first before you set up your above ground pool … This had to do with the poor packing job of the foundation by the former owner who installed the pool (according to my neighbor). If the difference in level is high, the entire liner is likely resting on sloping ground. Jun 17, 2010, 01:25 PM

I just got a 10 x 30 Intex pool and after we filled it up, it ended up being about 1 3/4 inch lower on the other end. Beyond that, you risk damaging your liner as well as its structure.In the most extreme cases, a part will get weakened, fail, and the liner will be liable to shatter. Pool must be level before installation, no chance after install is done.Above Ground Swimming Pool Installation Guide There is no way to level a pool after the base is down, no jacking, no lifting, no sand, no nothing is going to work. If you continue using the pool in that tilted position, you risk serious damage to your garden. Another is often how to level an above ground pool after it’s been filled with water. This is the only solution available to you. Half a centimeter can be enough to end up with a freestanding swimming pool that leans to one side. Then there is a good chance that they have sunk into the sand. If the pool tilts for more than two centimeters, you will have to empty the pool.

Now, I have a couple of questions to those who might know. The two main reasons are:Your floor may appear to be flat, but if your pool ends up tilting, it may not be flat enough. Ironically, the difference is only realized after filling the pool with water.A tilting above ground swimming pool due to an unlevel ground is not a problem you should take lightly. We recommend that you fix this problem as soon as possible.

I bought a pool last year, I think its about 14', its not one of those super nice ones with the deck attached or anything, just one of those 400 dollar ones from wal*mart... but I could never get it to stay up.. I think it was just not level enough last year, it would stay up fine for a couple...