What are the terms and conditions of my product ? How do I get my Kärcher product repaired under warranty ?
Each provides optimal, streak-free cleaning and protection with a fresh lemon scent.For the included sample bottles of Kärcher detergent, use about 1/3 to 1/2 of the sample bottle per tank (50ml) of fresh water.For the 16.9 oz bottles Kärcher detergents, 1/4 to 1/2 capful is recommended per tank (50ml) of fresh water.To avoid foaming, fill the tank with fresh water first.Kärcher FC 5 detergents are available here on this site and other leading online retailers.For ideal utilization and perfect results we recommend the use of Kärcher cleaning detergents. Manual will be automatically added to "My Manuals" With this pressure, the water is conveyed through the high-pressure hose to a lance, where it is ejected as a sharp, concentrated jet from a nozzle, creating enormous cleaning power. If the issue is not listed here, please con- tact customer service.
KÄRCHER. Find dealer/retailer: Send. However, unlike traditional wet mops or other wet floor cleaning devices, the FC5 uses a minimal amount of moisture to clean, leaving floors dry in two minutes and eliminating pooling where water can migrate under flooring.The FC5 is designed for use on nearly all hard floor surfaces including the following: natural hard woods, tile, stone including travertine, vinyl / PVC including Moduleo®, linoleum and Aguaguard™.Yes. This will draw water across the rollers and through the FC5 system. If the lowermost indicator light is the only light flashing, the machine’s battery was fully drainedRemove the suction head cover by first removing both rollersOnce the rollers are off, press the gray button on the front and pull the cover away from the machineHold the cover under running water in a manner that allows the water to reach any crevices in the coverRe-install the cover by holding horizontally and “clicking” back into the machineThe gray button should stick out a little bit if it is installed correctlyRemove the suction head cover and make sure there is nothing blocking the cavity where the rollers sitMake sure that the dirty water tank is not too full, particularly if you are using the device in a horizontal position or above your head.Charge the battery if the operating display is off or if it is flashing slowly. Details Reviews Specifications Karcher FC5 Floor Cleaner spare set of micro fibre rollers (2) with a grey colour band. Pressure washers are therefore easy on your budget as well as the environment.In an electric pressure washer, an electrically powered pump raises the water pressure by up to 40X. It does not clean into edges & corners as stated by Karcher. Coarse, natural stone will wear the rollers faster than if used on polished tile or hard floors. If the spray gun is not activated, the pump will switch off automatically. When the nozzle release button is depressed, the flow of detergent to the rollers is stopped.To empty the dirty water tank (on the back of the FC5), simple squeeze the top and pull out. 2 Roller working width (mm) 300 Equipment.
Daily use of the FC5 will wear the rollers faster than if used only once per week.For quick cleaning of the rollers, place the FC5 in the docking station, add water to the tray, and press the button to run the FC5 for 1-2 minutes. KÄRCHER.
A built-in suction function then removes the dirt, debris and dirty water from the rollers as they spin, so that you are always cleaning with fresh water.
Manual will be automatically added to "My Manuals" Page 21 Rollers do not turn Streaks on floor Rollers are blocked. The FC 5 can be used on all standard hard floors, including wood, stone, tile and linoleum. Remove the rubber stopper at top and fill with fresh water until the max fill line. Hard or wet leaves can quickly lead to blockages in the suction hose or container inlet.Level 2 is only used for operating power tools. Equipment. For quick cleaning of the rollers, place the FC5 in the docking station, add water to the tray, and press the button to run the FC5 for 1-2 minutes. To deep clean the rollers, turn the end of the each roller counterclockwise to remove from the FC5. 460 Power supply (Ph/V/ Hz) 1 / 120 / 60 Floor drying time (min.) Detergent used was not effective or im- Remove rollers and check if an ob- properly used. If you’ve already primed your FC5, check to make sure the nozzle cover is fully seated and the nozzle release button (gray) is fully raised. One of the mop rollers stripped the fabric off the first time I used it. QTY. QTY.